[Reception hours] 10: 00-18: 00 (excluding weekends and holidays)

Click here for online inquiries Inquiry form

3kW lens wind turbine

Outline of 3kW lens wind turbine

Single type 3kW lens wind turbine. Aiming to generate electricity at low cost in homes, businesses, and coastal areas with good wind conditions, the system has been introduced so far as power for lighting in local community squares and parking lots.
■Independent systems: 48 VDC or 96 VDC can be output to store electricity
■in storage batteries.A grid-connected version can also be installed.

Specifications of 3kW lens wind turbine

Rated output (Rated wind speed) 3kW (11m/s)
rotor diameter 2.78m
Wind collection lens outer diameter 3.64m
Diffuser (Wind collecting lens) Cii type, brim height 7.5%
hub height 12m (optional)
Wind collection lens upper end height 14.0m (optional)
Wind turbine body weight 590kg
wind turbine format With air collector/horizontal axis/downwind
blade 3 sheets, fixed pitch, GFRP
Generator Coreless multi-pole synchronous generator, outer rotor (rated speed 550rpm)
Yaw system passive
break short circuit brake
manual stop Possible (lever type switch)
Cut-in wind speed 3m/s
cutout wind speed 18m/s
wind resistance 59.5m/s (Class III)
for grid connection Possible
For independent power supply Capable of storing electricity at a voltage of 48-96V
tower Standard: Steel pipe monopole (Option: Retractable pole)

Features of the lens windmill (basic unit)

High efficiency

The Karman vortex generated by the "brim" of the diffuser with a brim creates a low-pressure area behind the diffuser, and this low-pressure area attracts wind. The accelerated wind increases 1.5 times at the blade tips and turns the wind turbine. Since wind energy is proportional to the cube of the wind speed, a wind turbine with the same rotor diameter can generate about 2 to 3 times as much power. The "lens wind turbine," which was optimized through a series of joint research efforts, is patented by Kyushu University, and we have obtained an exclusive license.


The blade tip vortices generated at the blade tips and the opposite-direction vortices induced by the diffuser's inner wall cancel each other out as they move downstream, suppressing the blade tip vortices that are the source of aerodynamic noise and significantly reducing the noise level. Noise measurements of a 3kW turbine showed a sound pressure level of less than 55dB near the wind turbine at wind speeds of 5 to 14m/s. The noise level is not noticeable even in residential areas. Noise is not a concern even in the vicinity of residential areas.

A wingtip vortex (blue) induces opposing vortices (red) on the inner wall of the ring (lens), which cancel each other out. The source of aerodynamic noise disappears.

bird strike

Diffusers (rings) are clearly visible to birds. "Bird strike", a collision between a bird and a blade, which is considered one of the major problems of wind power generation, has been confirmed to be less likely to occur. We have never experienced one until now.


Unlike conventional windmills, which have sharp-edged blades rotating at high speed, the soft image of the "ring" of the diffuser that surrounds the blades does not spoil the scenery, and it is easy to blend in with the surrounding scenery.

Expected power generation (1 kW lens wind turbine and 3 kW lens wind turbine)

Actual annual power generation depends on installation conditions (surrounding topography, weather conditions, etc.). The table below shows the amount of power generated based on our wind turbine power output curve and annual average wind speed, assuming a typical wind pattern (Rayleigh distribution). Considering self-consumption such as wind turbine system operation rate, generator efficiency, and inverter efficiency, the estimated power generation amount is shown as a reference annual power generation amount. 10% loss in grid inverter is assumed for grid connection. (Note: The capacity factor is based on our field test data. The two-year demonstration test from April 2016 to March 2018 in Hibikinada, Kitakyushu City)

Annual average wind speed Rated output (Rated wind speed) 1kW lens wind turbine 3kW lens wind turbine 9kW lens wind turbine
3.0m/s 6.0% 520kWh 1,570kWh 4,730kWh
4.0m/s 12.0% 1,050kWh 3,150kWh 9,460kWh
5.0m/s 20.0% 1,750kWh 5,250kWh 15,770kWh
6.0m/s 28.0% 2,450kWh 7,350kWh 22,070kWh
7.0m/s 35.0% 3,630kWh 9,190kWh 27,590kWh

Installation example of 3kW lens wind turbine


[Reception hours] 10: 00-18: 00
(excluding weekends and holidays)

Click here for online inquiries Inquiry form